pablo
RMS Moderator
- Messages
- 66,994
- Location
- Glengrimley
- Thread Starter
- #1,026
started into the aerocatches now that the spare "bonnet" arrived. Butchering time
You mightn’t have them to hand but and easier and handier way to cut that out would be to with 2 hole saws, smaller and bigger one to match the diameter at each end and then just have to cut the sides with a saw or grinder. Done it a few times when I was at rally cars.started into the aerocatches now that the spare "bonnet" arrived. Butchering time
View attachment 304286View attachment 304287View attachment 304288View attachment 304289
Not that I know of tbhDo they do a carbon fiber version of the front "bonnet" just curious as it would look wicked
Nice job mate. Fiddly enough to get rightNot that I know of tbh
One down one to go. Some faffing.
View attachment 304307View attachment 304308View attachment 304309View attachment 304310View attachment 304311
Never seen any with a different locking end. But tbh was never fitting any where that was an issuethe worst part is the pin is too tall so had to modify it so it would sit closer and let the bonnet close fully
must see if I can get shorter pins (the locking end, obv you can just cut the bottom end off to suit