mthompo
RMS Regular
- Messages
- 3,549
- Drives
- Too much...
Still in process of the engine rebuild on the midget although its very close to going back in now...subaru still not finished but this came up for sale cheap and its something i always wanted to own.
Shes not mint by any means needs wheels redone, steering is a bit vague noticed slight play in inner tie rods so will stick inner and outer on it here and needs an engine mount. Had to do rear wheel bearings as previous owner had done them but never put spacer back in, so they where buggered.
It was advertised that it had a 4 branch miltek and high lift cams.
Does have a miltek but its a cat back, there does appear to be a 4 branch but on reading up on it they did have them as standard and doesnt look to be stainless so who knows.
As for the cams i dont know it goes like the clappers and pulls hard throughout the rev range so quite possibly does, No proof though.
Its had its belt and dephaser pulleys done by rentec in scotland has 142k odd on it but does put a smile on the face, as for plans who knows will dicky up the wheels and get another center cap (ones missing) might take it to a rolling road to see whats going on but at the min just a bita crack any way couple of photos:
If anyone knows the car and can tell me anything about it sure get in touch
Shes not mint by any means needs wheels redone, steering is a bit vague noticed slight play in inner tie rods so will stick inner and outer on it here and needs an engine mount. Had to do rear wheel bearings as previous owner had done them but never put spacer back in, so they where buggered.
It was advertised that it had a 4 branch miltek and high lift cams.
Does have a miltek but its a cat back, there does appear to be a 4 branch but on reading up on it they did have them as standard and doesnt look to be stainless so who knows.
As for the cams i dont know it goes like the clappers and pulls hard throughout the rev range so quite possibly does, No proof though.
Its had its belt and dephaser pulleys done by rentec in scotland has 142k odd on it but does put a smile on the face, as for plans who knows will dicky up the wheels and get another center cap (ones missing) might take it to a rolling road to see whats going on but at the min just a bita crack any way couple of photos:
If anyone knows the car and can tell me anything about it sure get in touch