Blackline Performance Parts Thread
- Thread starter Blackline
- Start date
That is lethal!! Love the look of these!
Blackline
RMS Regular
OP
- Messages
- 220
- Thread Starter
- #55
Another selection of Millteks fitted recently.
First was this very smart Audi S6...
...we had previously fitted a "DropBox" to the factory air suspension allowing it to vent all air from the factory air suspension struts letting it sit on the floor. This time it was back to have a Milltek Sports Cat-back system fitted to not only repair a poor previous exhaust "modification" but release a bit more noise and performance from it too.
Next up was a pair of Yaris GRs!
Both the white and black cars got a cat-back Milltek system, but we also fitted a set of Eibach lowering springs, Powerflex caster adjustable front bushes and DNA Racing rear uniball joints to the rear swing arms on the black car to improve handling and stance.
First was this very smart Audi S6...
...we had previously fitted a "DropBox" to the factory air suspension allowing it to vent all air from the factory air suspension struts letting it sit on the floor. This time it was back to have a Milltek Sports Cat-back system fitted to not only repair a poor previous exhaust "modification" but release a bit more noise and performance from it too.
Next up was a pair of Yaris GRs!
Both the white and black cars got a cat-back Milltek system, but we also fitted a set of Eibach lowering springs, Powerflex caster adjustable front bushes and DNA Racing rear uniball joints to the rear swing arms on the black car to improve handling and stance.
Blackline
RMS Regular
OP
- Messages
- 220
- Thread Starter
- #59
You might have seen our van recently at the Titanic Dubs show but in case you haven't...
...we've made a few small changes over the course of this year.
We had the bottom end assembled with forged rods and pistons to cope with the 400hp it produces thanks to the TTE450 turbo, Loba high pressure fuel pump , Forge Motorsport intercooler and custom exhaust. We also facelifted it to a T6.1 front end, fitted the freshly refurbed BBS LMs by KLC and brought it up to Blackwater Graphics for some tidy graphics.
Since these photos were taken by the talented Matt Dobbs we've also fitted a Forge Motorsport big brake upgrade with 380mm discs and 6pot calipers!
We hope to make a few more changes to it before Dubshed so be sure to check it out the next chance you get.
...we've made a few small changes over the course of this year.
We had the bottom end assembled with forged rods and pistons to cope with the 400hp it produces thanks to the TTE450 turbo, Loba high pressure fuel pump , Forge Motorsport intercooler and custom exhaust. We also facelifted it to a T6.1 front end, fitted the freshly refurbed BBS LMs by KLC and brought it up to Blackwater Graphics for some tidy graphics.
Since these photos were taken by the talented Matt Dobbs we've also fitted a Forge Motorsport big brake upgrade with 380mm discs and 6pot calipers!
We hope to make a few more changes to it before Dubshed so be sure to check it out the next chance you get.