Fiesta Mk4 Bumpers... Onto a Mk3???

[Richy]

ive took a fancy to the mk4 bumpers. just wondering would there be much work to be done to get them onto a mk3 fez.

Id rather have the mk4 bumpers than the Si ones. hate those stupid lookin foglights on the Si bumpers.

This is the bumper in question....

 

[Steve]

rear is ok i think, but the front of the mk4 is too rounded at the lights and grill compared to the mk3, but could be made to fit i suppose

 

[Richy]

im wondering if the top 2 inches or so off a mk3 fez bumper cud be moulded onto that somehow.

would sovle the grill and light roundness problem....

 

[Steve]

sounds like too much hastle

 

[Porter]

the mk 4 and 5 can work,

but i think the mk3 is too square at the front for a mk 4 bumber

 

[buff]

aye theres a few blokes on FT.com that have mk4/5 fronts on the mk3 but im not sure if i like them though.

the Zetec-S rear is a good job though thats my plan

 

[turbod]

can u put a zetec-s rear bumper on a mk4?

 

[Porter]

i dont see why u cant, the shell of the car is the same,

mk4 and 5 im talkin about here when i say its the same shell

 

[turbod]

just had a look at my bumper, mk4 front bumper, and then looked at my neighbours mk3,

u wud need to do sum major adaption to get them to fit RITE

 

[AMG]

If you were going to go to the bother of joining the 2 different bumpers up, would it not be easier to fill in the fog light holes in the Si bumper????

 

[Richy]

you make a good point amg...

just another one of my stupid ideas, shot down like a beautiful swan by a pack of men with shotguns...

:?... i think i really shud go to bed

 

[JayT]

why not buy a bad ass bodykit with nice new bumpers, probably cost the same by the time you go round flushing and moulding them together.

 

[rsnutter]

stick an xr/rs kit on it, they look really well. or you could go the route aarons_ka (posts on BC) did with the wrc front bumper, rs 2000 skirts and the rs accessory(looks sorta like an escort cossie) rear bumper.

 

[Phil-Ray]

u can put a zs rear bumper on mk3 mk4 mk5

mk4 and 5 front bumpers are baiscly interchangeable iwth a little bit of cutting, not a big job tho.

to fit a mk4 or 5 bumoper on a mk3 needs a good bit of work and a bit of filler i think

 

[buff]

nope, mounts line up as do the arche lines and the top middle section needs trimed a little so it clears the back panel. not meant to be a big job to do

 

[Richy]

nope, mounts line up as do the arche lines and the top middle section needs trimed a little so it clears the back panel. not meant to be a big job to do

this for a mk4 bumper on to a mk3?

I wud guess the rear on goes straight on?

 

[Steve]

yeah rear goes straight on

 

[Richy]

good stuff, cheers mate