NovaGSi1600
RMS Member
- Messages
- 62
- Location
- Duleek ROI
Garage clearout....need to make space
Engines
Corsa A(Nova) GSi engine, e16se.
This engine was fitted to the Red Corsa A (Nova) that used to be down at the drag racing in Kildare years ago, it used to beat a lot of supposedly faster cars. It’s been sitting in my garage for a few years now. It was fully rebuilt by Dan Daly with new C16XE pistons, rings, P+P big valve head and Kent cam, new clutch.
It comes with loom, ECU and AFM, standard manifold. There is approx 4K miles on her since the rebuild. I took it as a part-ex against a calibra but have never used it.
SOLD
2L 16v Ecotec Engine,
new sump gasket and rocker cover gasket fitted, comes with ECU, key, transponder, loom, plumbing etc €100
Transmission:
F28 soldtransfer box, provisonally sold
F18cr , (came from an ecotec calibra), €50
Equal length drive shafts (came off a redtop calibra) with good cv’s and boots, 2 sets, €40 per set
Drive shafts, (came from an ecotec calibra) with good cv’s and boots €30
Brakes:
Front callipers (came off a redtop calibra), 2 sets, a must for a Manta, Nova or Corsa €25 per set
Discs, Vented, standard to suit the above callipers if fitting to a Nova or Corsa, €10 per set
Wheels:
15” original calibra alloys, 5 spoke, similar looking TSW’s, come with good tyres €100
Cav slabs with Vauxhall centre caps, need tyres, paint flaking in parts, €165
Calibra parts:
1. Front bumper, Spectral Blue €25
2. Rear bumper, Spectral Blue €25
3. Rear bumper, Black, fresh coat of paint, €50
4. Mirrors, LH and RH, not perfect, Blue €20 each
5. Suspension, standard front struts in good condition with 40mm lowering springs, wheel bearings in good condition, no noise €75 for the pair
6. Exhaust centre sections, standard, very good condition
7. power steering pumps €10
8. steering racks €40
9. rads €15
10. X20XEV engine mounts €5
11. C20XE engine mounts €5
Nova Parts:
1. Nova GSi head and cam box €75
2. Nova GSi ECU, loom, AFM €30
3. Nova GSi 4 branch manifold, 4 into 1 €35
4. Nova GSi inlet manifold, TB, fuel injectors €35
C20XE Parts:
Oil pick up pipe €5
Flat type fly wheel €20
Sump baffle plate €5
Distributer and cap Dizzy type ignition €10
Engine Loom and ECU - non dizzy €60
4 branch manifold qty 1, non-GM, Spurious, standard €40
Engine mounts €5
Oil breather/dip stick pipe €5
Cam cover - dizzy type €25
Inlet manifolds €15
Injectors, set of 4, €10
Throttle body’s €10
Fuel rails €5
Air boxes, €5
SFi boxes, €10
C20XE Irmscher UK Performance ECU
Irmscher Part No. ST1290030
Bosch PN: 0261200481
GM 90410502 GY
Suits early XE's with a Dizzy.
I don't know what the additional performance figures are. I called Irmscher about it years ago and they said there was additionl BHP, torque, better fuel economy and something about being mapped at every 250rpm for smother driving or something like that.
€65
More boxes of parts to go through out in the other shed, I'll keep adding to the list as I find more bits.
More Parts added 16/11/2011:
Calibra Head lamps €25
Calibra Tail lights €15
Calibra Turbo front discs, standard, nearly new, €25
C20XE plug cover, Vauxhall, metal, sand blasted and ready for paint €15
Calibra Jacking point covers for standard side skirts, full set, €10
Calibra original Mud flaps, Opel, full set €20
C20XE Oil breather/dip stick pipe, sand blasted and ready for paint, €5
C20XE Cam cover - dizzy type, sand blasted and ready for paint €25
C20XE timing belt cover, Early and Late types, sand blasted and ready for paint, €25
Calibra Oil/Volt gauge set, standard, €15
Calibra Black leather passenger door card €25
Calibra Black leather rear cards, LH and RH, €15 each
C20XE hydraulic lifters, standard, full set, bought new from Classic Spares Network at Billing, €60
LET Parts:
KKK16 turbo, stripped, bought for spares, all parts cleaned, needs new wheel and shaft, €45
C20LET Charge cooler, make unknown, complete kit, €85
C20LET Lambda sensor, €35
Calibra Turbo Exhaust down pipe, for KKK16, standard, €25
Calibra Turbo Cat, €75
Calibra Turbo rad and fan, €40
Cheers,
Mick
+353-87-8339477
Engines
Corsa A(Nova) GSi engine, e16se.
This engine was fitted to the Red Corsa A (Nova) that used to be down at the drag racing in Kildare years ago, it used to beat a lot of supposedly faster cars. It’s been sitting in my garage for a few years now. It was fully rebuilt by Dan Daly with new C16XE pistons, rings, P+P big valve head and Kent cam, new clutch.
It comes with loom, ECU and AFM, standard manifold. There is approx 4K miles on her since the rebuild. I took it as a part-ex against a calibra but have never used it.
SOLD
2L 16v Ecotec Engine,
new sump gasket and rocker cover gasket fitted, comes with ECU, key, transponder, loom, plumbing etc €100
Transmission:
F28 soldtransfer box, provisonally sold
F18cr , (came from an ecotec calibra), €50
Equal length drive shafts (came off a redtop calibra) with good cv’s and boots, 2 sets, €40 per set
Drive shafts, (came from an ecotec calibra) with good cv’s and boots €30
Brakes:
Front callipers (came off a redtop calibra), 2 sets, a must for a Manta, Nova or Corsa €25 per set
Discs, Vented, standard to suit the above callipers if fitting to a Nova or Corsa, €10 per set
Wheels:
15” original calibra alloys, 5 spoke, similar looking TSW’s, come with good tyres €100
Cav slabs with Vauxhall centre caps, need tyres, paint flaking in parts, €165
Calibra parts:
1. Front bumper, Spectral Blue €25
2. Rear bumper, Spectral Blue €25
3. Rear bumper, Black, fresh coat of paint, €50
4. Mirrors, LH and RH, not perfect, Blue €20 each
5. Suspension, standard front struts in good condition with 40mm lowering springs, wheel bearings in good condition, no noise €75 for the pair
6. Exhaust centre sections, standard, very good condition
7. power steering pumps €10
8. steering racks €40
9. rads €15
10. X20XEV engine mounts €5
11. C20XE engine mounts €5
Nova Parts:
1. Nova GSi head and cam box €75
2. Nova GSi ECU, loom, AFM €30
3. Nova GSi 4 branch manifold, 4 into 1 €35
4. Nova GSi inlet manifold, TB, fuel injectors €35
C20XE Parts:
Oil pick up pipe €5
Flat type fly wheel €20
Sump baffle plate €5
Distributer and cap Dizzy type ignition €10
Engine Loom and ECU - non dizzy €60
4 branch manifold qty 1, non-GM, Spurious, standard €40
Engine mounts €5
Oil breather/dip stick pipe €5
Cam cover - dizzy type €25
Inlet manifolds €15
Injectors, set of 4, €10
Throttle body’s €10
Fuel rails €5
Air boxes, €5
SFi boxes, €10
C20XE Irmscher UK Performance ECU
Irmscher Part No. ST1290030
Bosch PN: 0261200481
GM 90410502 GY
Suits early XE's with a Dizzy.
I don't know what the additional performance figures are. I called Irmscher about it years ago and they said there was additionl BHP, torque, better fuel economy and something about being mapped at every 250rpm for smother driving or something like that.
€65
More boxes of parts to go through out in the other shed, I'll keep adding to the list as I find more bits.
More Parts added 16/11/2011:
Calibra Head lamps €25
Calibra Tail lights €15
Calibra Turbo front discs, standard, nearly new, €25
C20XE plug cover, Vauxhall, metal, sand blasted and ready for paint €15
Calibra Jacking point covers for standard side skirts, full set, €10
Calibra original Mud flaps, Opel, full set €20
C20XE Oil breather/dip stick pipe, sand blasted and ready for paint, €5
C20XE Cam cover - dizzy type, sand blasted and ready for paint €25
C20XE timing belt cover, Early and Late types, sand blasted and ready for paint, €25
Calibra Oil/Volt gauge set, standard, €15
Calibra Black leather passenger door card €25
Calibra Black leather rear cards, LH and RH, €15 each
C20XE hydraulic lifters, standard, full set, bought new from Classic Spares Network at Billing, €60
LET Parts:
KKK16 turbo, stripped, bought for spares, all parts cleaned, needs new wheel and shaft, €45
C20LET Charge cooler, make unknown, complete kit, €85
C20LET Lambda sensor, €35
Calibra Turbo Exhaust down pipe, for KKK16, standard, €25
Calibra Turbo Cat, €75
Calibra Turbo rad and fan, €40
Cheers,
Mick
+353-87-8339477