Splitter bonding

[mark19]

So fitted an non oem splitter to my BMW and used the oem mounting points as much as possible

However its starting to sag slightly in the middle and was going try more plastic rivets but don't really wanna drill much more. Is there a type of bonder I can use to keep it tight to the bumper? And like how much drying time etc as well?

 

[Gareth]

Do you ever want it off again? If not then this stuff,

 

[mark19]

Well would like the idea if it breaks etc can remove it?

 

[Gambit]

Just use 3m double tape on it

 

[RevT]

3M double tape in the right size or CT1 / Tec7 will do the job.

 

[mark19]

For some reason I just don't think tape will stick a saggy splitter aha does it not just come undone after a while?

 

[RevT]

For some reason I just don't think tape will stick a saggy splitter aha does it not just come undone after a while?

Proper 3M tape and apply it properly it should never come undone.

 

[Paddy_R]

When I had the Golf R I used Gorilla Tape Heavy duty mounting tape to attach the side skirts and rear spats. Were on the car circa 18 months when I sold it without an issue. Its about £5 a roll from Amazon.

 

[Apis]

I'd give that a go with a tube of Gripfill.

 

[ShaunB]

I wouldn't use gripfill, i'd go with CT1.

 

[mark19]

I hope he was taking the piss or I'll gripfil him in lol