fabiostar
RMS Regular
i suppose it depends on the tip used for machining, some are £10-15 each, some are £20 and then some
you can machine a few discs with 1 tip though
probably also the disc material too,
me thinks its better to keep the factory discs and machine, than put on cheap ****te, that dont help with stopping lol
mine are factory mazda and have 1.8mm left, only need slight lip taken off, so worth machining etc
have always checked disc thickness and machined if enough meat depending on make of disc etc,
not the norm here though, probably why its more expensive to do here
set up time etc, most are probably using a lathe instead of the disc machine etc
if i can fit them into my lathe its a simple enough job to do sir