Lappintyre
RMS Regular
What way is it going after the work at BBR?
I’ve only had a quick 5 minute run in it but it’s a different car altogether. The standard ND1 2.0 engine is unwilling to rev and feels like it being held back. It now pulls really smooth right up to the limiter, which is also about 1000rpm higher than before. With our crappy fuel it got 199bhp so with some 99 it should get a few more as these engines with their high compression 13.5:1 apparently benefit from it.What way is it going after the work at BBR?
Think it's a cost saving measure in the factories. Fit a standard loom during build, and tie back and blank off any options not on the build list.Thanks guys for the comments.
Fitted the Mazda 6 boot opening switch this evening. I was a surprised to find a wired plug inserted into the blanking plate. I just had to find the right wire to trigger the boot and piggyback onto it. It even lights up like the other switches
View attachment 364102View attachment 364103View attachment 364108View attachment 364104View attachment 364105View attachment 364106View attachment 364107View attachment 364113View attachment 364110View attachment 364111View attachment 364112
Cheers Johnny! It is the GoPro Hero 10. It’s just the in-built mic but cause it was on the bumper the wind didn’t get at it. I’m going to buy the foam wind blocker for it, as I tried another video with it on the quarter panel and the wind was obvious.What a noise!! BBR certainly got it revving!
What version of a go pro is this? Audio is excellent.... that the inbuilt mic or a remote mic away from the wind?