@Gareth Looks great! Are you using panel wipe after polishing?
Kinda. Is AngelWax Striped Ease too aggressive?
What you are experiencing is "sticky" paint. To get round it add a little finishing polish into your cutting stage. Something really oily like Megs 205 will really help with residue removal. Also work in smaller sections as it keeps the polish active.
As the polish dries and bakes on sticky paint, when you go over it with the machine, you are then introducing the marring. So smaller sections and a mix with oily finishing polish will drastically reduce it.
If you have a rotary, finish down with it at lowish speed with a very oily finishing polish and it will really sharpen the finish and take out any remaining marring
I've not got a rotary. Just the 75 and a 15. I never took the 15 out of the bag. The area I was working was small, but maybe not small enough? I know you've mentioned adding 205 into the mix before, and I keep forgetting.
As for speeds, I actually didn't get much above speed 1 throughout all 3 stages. I ramped up the finishing stage to 3 on my last pass, but that's as high as I'd got.